DSE E100

Features:



ENGINE ONLY CONTROLLER 

DSE E100 is an Engine only Controller has built-in analog Sensors for oil pressure, coolant temperature, fuel level monitoring along with start / Stop.

Application : Engine driven pumps and compressors.

Category:
Brands:DSE

Enquiry about DSE E100

Description

DSE E100 is an easy to use non electronic (Conventional) engine only controller designed to provide flexible control with built in monitoring and protection.

PRODUCT HIGHLIGHTS

I/O
– Configurable analogue / digital inputs (3)
– Configurable digital inputs (4)
– Configurable remote start input
– Configurable DC outputs (4)
– Fuel and start outputs

 

COMMUNICATIONS
– USB for PC configuration
– DSEWebNet® compatible

 

ENGINE COMPATIBILITY
– Conventional engine support (MPU & W terminal)

 

CONFIGURATION
– DSE Configuration Suite PC software
– Front panel (PIN protected)

 

ADVANCED FEATURES
– 3 engine maintenance alarms
– Engine speed protection
– Comprehensive warning, controlled shut down or shut down protection on fault condition
– Engine hours counter
– Real-time clock for accurate event logging
– Engine pre-heat
– Engine run-time scheduler
– Battery voltage monitoring
– Large display screen
– Power save mode
– Start on low battery voltage

 

 

 

Protection Functions

  • Engine speed protection Under / Over Speed (with MPU only)
  • Low Oil Pressure (Sensor / Switch input)
  • High Coolant (Water) Temperature (Sensor / Switch input)
  • Low Fuel Level (Sensor / Switch input)
  • Emergency Stop
  • Charger Alternator Fail
  • Low / High Battery Voltage

Hardware

  • Dimension Details:

    • Over All Dimension – 140 mm x 113 mm x 43 mm
    • Panel Cut Out Dimension – 118 mm x 92 mm

  • DC SUPPLY

    CONTINUOUS VOTLAGE RATING
    8 V to 35 V continuous

    CRANKING DROPUTS
    Able to survive 0 V for 50 mS, providing supply was at least 10 V before dropout and supply recovers to 5 V. This is achieved without the need for internal batteries.

    MAXIMUM OPERATING CURRENT
    85 mA at 12 V, 96 mA at 24 V

    MAXIMUM STANDBY CURRENT
    51 mA at 12 V, 47 mA at 24 V

    MAXIMUM SLEEP CURRENT
    35 mA at 12 V, 32 mA at 24 V

    CHARGE FAIL/EXCITATION RANGE
    0 V to 35 V

  • INPUTS

    DIGITAL INPUTS A to D
    Negative switching

    ANALOGUE INPUTS A to C
    Configurable as:
    Negative switching digital input
    Resistive

  • OUTPUTS

    DC OUTPUT A (FUEL) & B (START)
    10 A short-term
    5 A continuous at supply voltage

    VOLT-FREE OUTPUTS C & D
    2 A DC at supply voltage

    AUXILIARY OUTPUTS C, D, E & F
    2 A DC at supply voltage

    PULSE PICK-UP

    VOLTAGE RANGE
    +/- 0.5 V to 70 V

    FREQUENCY RANGE
    5 Hz to 10,000 Hz

Standards

Connection Diagram

Related products